geometry calculators

'To the point' advice on what fits what, parts interchangeability and simple solutions to common problems...
This forum applies to any make.
Keep your post brief. You may include 2-3 clear cropped photos (max 600 pixels wide)...
Post Reply
neale
Posts: 280
Joined: Mon Apr 09, 2012 6:57 pm
Location: Sydeny NSW

geometry calculators

Post by neale » Thu Jun 21, 2012 9:50 pm

I understand that this is related to topics which have been discussed before (probably NUMEROUS times), but I was hoping that someone may know of a calculator which will provide the changes to wheelbase and headstem height with rake changes?

This one http://www.rbracing-rsr.com/advchoppercalc.html gives MOST details, but the affect on wheelbase can't be extracted, as they one of their mandatory inputs :o(

I do realise that a more accurate measurement would be to check physically, but that's difficult without a decent setup to work on things, which I ain't got yet. ( I also need to get an angle checker ASAP, I know )

So, any pointers would be greatly appreciated.

Thanks,

Neale
Neale
'85 XV1000 with some mods, getting there
'86 XT600Z, going under the knife ASAP

neale
Posts: 280
Joined: Mon Apr 09, 2012 6:57 pm
Location: Sydeny NSW

Re: geometry calculators

Post by neale » Sun Jun 24, 2012 1:01 pm

FWIW, if anyone had any interest, I found a separate calculator which provided the extra numbers that I was looking to plug into the rbracing calculator, http://www.csgnetwork.com/righttricalc.html

Catch ya,

Neale
Neale
'85 XV1000 with some mods, getting there
'86 XT600Z, going under the knife ASAP

Post Reply

Return to “Fits 'n Bits; general...”