Need to scrap rim?

'To the point' advice on what fits what, parts interchangeability and simple solutions to common problems...
This forum applies to any make.
Keep your post brief. You may include 2-3 clear cropped photos (max 600 pixels wide)...
Post Reply
neale
Posts: 280
Joined: Mon Apr 09, 2012 6:57 pm
Location: Sydeny NSW

Need to scrap rim?

Post by neale » Sat Jun 30, 2012 2:31 am

I expect that I know the answer to this, but is there any chance of straightening this rim, and if so, any suggestions about how/where to get it done?

Image

It'd be nice to not have to get a new rim laced onto the hub if it wasn't beyond recovery, it looks bad to me, but I know bugger all about these things nowadays.

Thanks,

Neale
Neale
'85 XV1000 with some mods, getting there
'86 XT600Z, going under the knife ASAP

Post Reply

Return to “Fits 'n Bits; general...”